Normal Copying - Sharp AR-235 Operation Manual

NORMAL COPYING

The basic copying procedure is described below.
q
Image loss (max. 4 mm (5/32")) can occur at the leading and trailing edges of the copies. Also image
loss (max. 3 mm (1/8")) can occur along the other edges of the copies.
NOTE:
If the copier has been programmed in the auditing mode, enter a 5-digit account number.
See page 20.
1
Place an original face down on the platen glass and align it with the
original size scale.
q
The detected original size will be indicated in the display.
NOTE:
If the original size cannot be detected, the original size can be entered as follows. Press the
SPECIAL FUNCTION key. Use the
the OK key. Use the
desired original size. Press the OK key.
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
2
Close the platen cover.
q
Paper matching the size of the original will be automatically selected when the auto
paper select function has been enabled. To copy onto paper of a different size, press the
PAPER SELECT key.
q
Paper of the different orientation may be selected if the auto paper select or auto image
function has been selected. In this case, the image of the original will be rotated and
copied. See page 35.
5KEY OPERATOR The auto paper select function can be disabled using a key operator
program. If this function is disabled, use the PAPER SELECT key to select the desired
paper tray. See page 134.
24
and keys to select "ORIG. SIZE ENTER" and then press
and key to select "AB" or "INCH" and use the and
ORIG. SIZE ENTER
AB
A3
B4
A4
keys to select the