Removing The Processor; Installing A Pci Card - MAXDATA PLATINUM 500 I M5 System Manual

Removing the Processor

To remove the processor, follow these instructions:
1. Observe the safety and ESD precautions at the beginning of this book.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Remove power from your system by unplugging the AC power cord.
4. Remove the chassis cover. See your chassis documentation for instructions.
5. Disconnect the processor fan cable.
6. Fully loosen the four captive screws on the heat sink.
7. Twist the heat sink to break the seal between the TIM and the processor.
CAUTIONS
Do not attempt to lift the heat sink from the processor without first twisting it to break the seal
between the TIM and the processor. Lifting the heat sink without breaking the seal may damage the
processor or the processor socket.
8. Lift the heat sink from the processor.
9. Lift the processor lever.
10. Remove the processor.
11. Reconnect or replace any internal components you needed to disconnect or remove.
12. Replace the server's cover. Reconnect any external components you needed to disconnect.
13. Attach the AC power cord.

Installing a PCI Card

Peripherals and add-in cards are not included in your system and must be purchased separately.
The PCI slots support full-height add-in cards or low-profile PCI add-in cards. If a low profile card is
installed in the standard full-height riser card, it must be equipped with a standard full-height PCI
mounting bracket.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Remove power from your system by unplugging the AC power cord.
4. Remove the chassis cover. See your chassis documentation for instructions.
5. Remove the screw that attaches the PCI bracket shield to the rear of the chassis to remove
the shield. Retain the screw.
6. Insert the PCI card into the PCI slot.
7. Use the screw removed in step 1 to secure the PCI card to the chassis.
8. Reconnect or replace any internal components you needed to disconnect or remove.
9. Replace the server's cover. Reconnect any external components you needed to disconnect.
10. Attach the AC power cord.
MAXDATA Server PLATINUM 500 I M5 MAXDATA Server PLATINUM 500 I M5 19 19