Table of Contents
Advertisement
D i s p l a y
The display intensity (
manually set the intensity to a level from
The display on/off setting (
minutes after the last key press (
To flip the display, press [Up] and [Down] simultaneously.
L a m p
There are two settings that modify lamp control: Automatic Lamp On (
(
PER S>DL oF
When
A LON
strikes automatically after the fixture is powered on. When
the fixture receives DMX data, and it extinguishes 15 minutes after DMX data is lost.
A L O N
When
striking at once. The delay is determined by the fixture address.
The DMX Lamp Off (
off the lamp. The special combination of DMX values listed on page 14 allows you to execute the lamp-off command
even when disabled.
D M X r e s e t
The DMX reset (
is fully enabled. When set to
command must be sent for five seconds.
Readouts
T i m e
INF O>T IME
each item is a resettable (
hours/strikes since fabrication. To reset an increment counter, display it and then press [Up] until it reads 0.
T e m p e r a t u r e
INF O>T EMP
F i r m w a r e v e r s i o n
INF O>V ER
startup.
D M X
The DMX log (
R A T E
displays the DMX refresh rate in packets per second. Values lower than 10 or higher than 44 may result in
erratic performance, especially when using tracking control.
qU A L
displays the quality of the received DMX data as a percentage of packets received. Values much below 100
indicate interference, poor connections, or other problems with the serial data link that are the most common cause of
control problems.
STC O
displays the DMX start code. Packets with a start code other than 0 may cause irregular performance.
The remaining options under
as expected, reading the DMX values can help you troubleshoot the problem.
12
P E R S
>
d I NT
) setting controls display brightness. Select
10
P E R S
d I S P
>
2 MN
), or for 10 minutes after the last key press (
).
is
OF F
, the lamp remains off until a "lamp on" command is received. When
O N
D M X
is set to either
or
DL oF
) setting allows you to enable (
PERS >dR ES
) setting controls the behavior of the reset command. When set to
O F F
, the command is disabled to prevent accidental resets. When set to
provides readouts of fixture hours (
R S E T
) increment counter and a non-resettable (
provides readouts of the head and base temperature in Celsius and Fahrenheit.
displays the version number of the installed firmware. The firmware version is also displayed briefly at
dMX L
) menu provides useful information for troubleshooting control problems.
d MXL
display the DMX values received on each channel. If the fixture does not behave
MAC 550 Profile
10 0
to
.
) determines whether the display remains on (
AL ON
is set to
, the automatic lamp strike timing is staggered to prevent all lamps from
O N
) or disable (
HR S
), lamp hours (
A U T O
for automatic display or
O N
), remains on for 2
10 MN
).
P E R S
>
A L O N
) and DMX Lamp Off
A LON
is
DM X
, the lamp strikes automatically when
O FF
) the DMX command that switches
ON
L HR
), and lamp strikes (
L ST
T O T L
) counter for total accumulated
ON
, the lamp
, the command
5 S E C
, the
). Under
Hide quick links:
Advertisement
Table of Contents
