Panasonic Viera TX-P42GT30E Operating Instructions Manual page 52

Update DVB channel automatically [Update Channel List]
You can add new channels, delete removed channels, update channel name and position automatically to Channel List.
DVB-T Update Channel List
Progress CH 5
This will take about 3 minutes.
CH Channel Name
Free TV: 0 Pay TV: 0
Searching
Display a notification message [New Channel Message]
Selects whether to give a notification message when a new DVB channel is found. [Off] / [On]
New channels found!
Press OK to update channel list.
Press EXIT to ignore.
Check DVB signal [Signal Condition]
Selects a channel and checks the DVB signal condition.
A good Signal Strength is not an indication of suitable signal for DVB reception.
Please use the Signal Quality indicator as follows :
[Signal Quality] :
•
Green bar Good
•
Yellow bar Poor
•
Red bar Bad (Check the Terrestrial aerial, cable or Satellite dish)
Example :
DVB-C Signal Condition
Channel Name
Signal Quality
Signal Strength
Bit Error Rate
Network Name
Parameter
Reduce the DVB-C signal [Attenuator]
If the DVB-C signal is too strong, the interference may occur. In this case set to [On] to reduce the signal automatically.
•
This function is available only for DVB-C signal.
52
•
Channel List is updated while keeping your settings in [Favourites Edit],
69
[Channel List], [Child Lock], etc.
•
Depending on the signal condition, the update may not work properly.
Type Quality
•
To update DVB-S channels, the satellite, search mode and scan mode settings
are required before updating.
Radio: 0
DVB-S Update Channel List Settings
Satellite
Search Mode
Scan Mode
•
Selecting OK will perform [Update Channel List].
70 CBBC Channel
90 %
These bars show the maximum signal value of the selected channel.
80 %
0.00E+00
Wenvoe
802,00 MHz, 64 QAM, 6940 kS/s
Astra 19.2° E
Free Channels
Quick
•
Start scan
select
access / store
After settings, select [Start scan].
•
To change the channel