Panasonic Viera TX-P42GT30E Operating Instructions Manual page 115

Problem
Chaotic image, noisy
No image can be displayed
Blurry or distorted image
(no sound or low volume)
Unusual image is displayed
No sound is produced
Sound level is low or sound
is distorted
Unusual sound from the TV
Cannot see 3D images
3D Eyewear is turned off
automatically
There is something wrong
with the 3D images
The indicator lamp does
not light when pressing the
power button on the 3D
Eyewear
Sound is unusual
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
•
Set [P-NR] in the Picture Menu (to remove noise).
•
Check nearby electrical products (car, motorcycle, fluorescent lamp).
•
Is [Contrast], [Brightness] or [Colour] in the Picture Menu set to the minimum?
(p. 36)
•
Reset channels. (p. 45 - 48)
•
Turn the TV Off with Mains power On / Off switch, then turn it On again.
•
If the problem persists, initialise all settings
•
Is "Sound mute" active?
•
Is the volume set to the minimum?
•
Sound signal reception may be deteriorated.
•
Set [MPX] (p. 39) in the Sound Menu to [Mono]. (Analogue only)
•
When power is on, whirring sound of cooling fan or drive noise may be heard from
inside the TV (not a sign of faulty operation).
•
Has the 3D Eyewear been switched On?
•
Ensure that [3D Mode Selection] is set to [3D].
•
Some 3D image signals may not be automatically recognised as 3D images. Set [3D
Mode Selection (Manual)] to match the picture format.
•
Check that there are no obstacles between the infrared sensors on the TV and the 3D
Eyewear. If the 3D Eyewear stops receiving the infrared signal for about 5 minutes,
the 3D Eyewear will be turned off automatically.
•
Check the available area to use the 3D Eyewear.
•
Depending on the person, the 3D images may be difficult to see, or cannot be seen,
especially in users that have a different level of eyesight between the left and right
eyes.
Take the necessary steps (wearing glasses etc.) to correct your eyesight before use.
•
Check that there are no obstacles between the infrared sensors on the TV and the
3D Eyewear or that the 3D Eyewear is placed inside the coverage area (p. 33). If the
3D Eyewear stops receiving the infrared signal for about 5 minutes, the 3D Eyewear
will be turned off automatically.
•
Check the setting of [Picture Sequence] or [Edge Smoother].
•
The battery may be running low or flat. Replace it.
•
Set the sound setting of the connected equipment to "2ch L.PCM".
•
Check the [HDMI1 / 2 / 3 / 4 Input] setting in the Sound Menu.
•
If digital sound connection has a problem, select analogue sound connection.
(p. 111)
•
Check the HDMI cable is connected properly.
•
Turn the TV and equipment Off, then turn them On again.
•
Check an input signal from the equipment.
•
Use equipment compliant with EIA/CEA-861/861D.
Actions
(p. 37)
[Shipping Condition] (p. 62)
(p. 9)
(p. 31)
(p. 33)
(p. 104)
(p. 113)
(p. 31)
(p. 33)
(p. 40)
115