Related Manuals for Hans Grohe Talis S 32111XX1
Summary of Contents for Hans Grohe Talis S 32111XX1
- Page 1 Installation Instructions / Warranty Talis S² 32110XX1 32112XX1 Talis S² 32111XX1 32113XX1...
-
Page 2: Technical Information
Talis S² 32110XX1 / 32112XX1 Technical Information Recommended water pressure Max. water pressure Max. hot water temp. Recommended hot water temp. Flow rate Battery (32210/32212 only) Automatic shutoff *Please know and follow all local plumbing codes when setting the temperature on the water heater. In Massachusetts, the water heater may be set no higher than 112 Talis S²... - Page 3 Do not install this faucet on a sink with a raised lip. Do not bend or twist the supply hoses!
-
Page 4: Installation Notes
Installation notes • Flush the hot and cold supplies thoroughly before installing the faucet. Damage to the faucet caused by debris is not covered under the warranty. • The hot and cold supplies should be of equal pressure. • The faucet should not be used with a con- tinuous flow water heater. -
Page 5: Installation
Installation Position the faucet on the sink or countertop (1). Install and tighten the mounting nut (2). Tighten the tensioning screws (3). Connect the 3/8” adapters to the stops (4). Connect the hoses to the adapters (5). Tighten the hoses with two wrenches, as shown, to prevent the hoses from twisting. - Page 6 Connect the faucet power cable to the battery pack or AC power pack (1). Plug the AC power pack in. Turn the hot and cold supplies on (2). Remove the protective film from the sensor window (3). Wait 30 seconds before attempting to use the faucet (4).
- Page 7 Remove the faucet body (1). Turn the temperature screw forward to make the water cooler, backward to make it warmer (2). Dry any drops of water from the faucet or mounting surface. Replace the faucet body (1). Replace the screw (2). Turn the water supplies on (3).
- Page 8 Battery replacement -- models 32110XX1 / 32111XX1 only If the LED in the sensor window flashes, the battery is low, but the faucet can still be used. If the LED lights continuously, the battery must be changed before the faucet can be used. Remove the four screws and the battery pack cover.
- Page 9 Clean the aerator and filters -- all models If the water flow is reduced over time, clean the aerator (a) and the filters (b). Turn the water supplies off (1). Disconnect the power cable (2). Unscrew the aerator (a) with the service key. Disconnect the hot and cold supply hoses from the adapters.
- Page 10 Wait 30 seconds (1). Place a hand in front of the sensor to turn the faucet on (2).
- Page 11 Cleaning The faucet may be turned off temporarily so that the sink may be cleaned. Cover the sensor window with a hand for approximately 10 seconds. The faucet will turn off for approximately 60 seconds, so that the sink may be cleaned. The LED in the sensor window will flash.
- Page 12 Reduce the sensor range The sensor is set for maximum range at the factory. If the faucet is used on a very small or highly reflective lavatory, the sensor range may be reduced by ap- proximately 2”. Disconnect the power cable for approximately 10 seconds (1).
-
Page 13: Replacement Parts
Replacement Parts aerator fixing set AC adapter battery, lithium battery box connection hose electronics check valve aerator service key 8802XX0 XX = color 1361000 00 = chrome 82 = brushed nickel CR-P2 / 6V 8801000 880000 8803000 6456000 Maintenance note: the check valves (item #8) 8808000 should be removed and checked yearly. -
Page 14: Limited Lifetime Consumer Warranty
Cleaning Recommendation for Hansgrohe Products Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain criteria when cleaning. - Page 15 the product for use primarily for any other purpose, including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe and Commercial products, and (ii) for 5 years, with respect to AXOR products. THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A.
- Page 16 Hansgrohe, Inc. • 140 Bluegrass Lakes Parkway • Alpharetta, GA 30004 Tel. 770-360-880 • Fax 770-360-887 www.hansgrohe-usa.com...