Torque Limiter - Makita HR4001C Instruction Manual

HR4001C /HR4010C
1. Change lever
2. Pointer
3. Lock button
3
HR4001C
HR4010C
1. Change lever
2. Pointer
3. Lock button
3
1. Change lever
2. Pointer
3. Lock button
Hammering only
FOR MODEL HR4001C AND HR4010C
006311
For chipping, scaling or demolition operations, depress the lock button and
rotate the change lever so that the pointer points to the
3
point, cold chisel, scaling chisel, etc.
2
1
For long time hammering (FOR MODELS HR4001C AND HR4010C ONLY)
006313
For chipping, scaling or demolition operations, depress the lock button and
rotate the change lever so that the pointer points to the
2
point, cold chisel, scaling chisel, etc.
CAUTION:
• When using the tool in the
work and only the slide switch works.
1
FOR MODEL HR4011C
006312
HR4011C
For chipping, scaling or demolition operations, depress the lock button and
rotate the change lever so that the pointer points to the
point, cold chisel, scaling chisel, etc.
CAUTION:
2
• Do not rotate the change lever when the tool is running under load. The
1
tool will be damaged.
• To avoid rapid wear on the mode change mechanism, be sure that the
change lever is always positively located in one of the two or three action
mode positions.

Torque limiter

The torque limiter will actuate when a certain torque level is reached. The
motor will disengage from the output shaft. When this happens, the bit will stop
turning.
CAUTION:
• As soon as the torque limiter actuates, switch off the tool immediately.
This will help prevent premature wear of the tool.
symbol. Use a bull
symbol mode, the switch trigger does not
symbol. Use a bull
symbol. Use a bull
7