Makita HR4001C Instruction Manual page 9

2
1
1. Bit shank
2. Bit grease
1
2
1. Bit
2. Chuck cover
1
2
1. Bit
2. Chuck cover
Installing or removing the bit
003150
Clean the bit shank and apply bit grease before installing the bit.
Insert the bit into the tool. Turn the bit and push it in until it engages.
006318
If the bit cannot be pushed in, remove the bit. Pull the chuck cover down a cou-
ple of times. Then insert the bit again. Turn the bit and push it in until it
engages.
After installing, always make sure that the bit is securely held in place by trying
to pull it out.
To remove the bit, pull the chuck cover down all the way and pull the bit out.
006333
9