Showerhead Installation Remove the old showerhead: While holding the shower arm, remove the exist- ing showerhead by turning counter-clockwise with a wrench. Clean the threads on the shower arm with a wire brush. Install the new showerhead: Slide the boot onto the shower arm. Push it out of the way.
If the flow of water becomes noticeably less, remove and clean the screen washer. User Instructions Change the spray mode - models 06126XX0 and 06127XX0 only selector lever Scale Removal Rubit Self Cleaning System The Retroaktiv showerheads and handshower use the Rubit self cleaning system.
Page 5
If scale deposits are noticed on the spray face, pour about 3/” of a commercial scale remover, such as Lime-Away or CLR ,into a shallow dish. Dilute the remover according to the label instructions. Soak only the spray face in the solution for the amount of time specified on the label.
Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: Conditions, malfunctions or damage not resulting from defects in material or workmanship. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions.