Turning The Power For Home Theatre System Devices On And Off At Once; Using The Macro Function; Setting The Macro Function - Panasonic PT-AE900U Operating Manual

Turning the power for home theatre system devices on and off at once

You can use the projector's remote control to turn the power on and off for home theatre
system devices that have been recorded in the remote control.
Note:
BAt the time of purchase, a macro for turning the power on and off for PJ,
DVD, VCR and AMP all at once is set.
I Using the macro function
Press and hold [SYSTEM] for 3 seconds or more.
The power for the registered devices will turn on.
✱ The length of time required for the macro function to finish operating effectively will vary
depending on the number of devices that have been recorded.
I Setting the macro function
Note:
B If the distance that the projector's remote control has to operate is too far, or if
the remove control receiver of the home theatre system devices are obstructed,
this operation may not work correctly. Check the locations and directions of the
home theatre system devices to make sure that they can all be operated.
1
Press [SETUP] for 3 seconds or more.
2
Select "USER 1-3" and then press [ENTER].
3
Select "MACRO?" and then press [ENTER].
18
(Example: When "USER1" is selected)
✱ The display will show the
devices that have been
recorded by the macro.
4
Select the device to be registered.
✱ If a registered device is selected, the display will flash faster.
5
Press [SYSTEM].
✱ If a registered device is selected, the display will flash faster.
✱ To register or delete another device, repeat steps 4 and 5.
Clearing the macro function
Press [SYSTEM] once more.
✱ The macro function will be cleared and the display will flash more
slowly.
6
When you have finished selecting
devices, press [ENTER].
To finish, press [SETUP], and then check operation.
(Example: When "USER3" is selected)
(Example: When "USER3" is selected)
19