Panasonic PT-AE900U Operating Manual page 7

Setting remote control signals for home theatre systems
I Learning remote control signals directly from home
theatre system devices
If operation is not possible using a device code, you can register other remote control
signals for the USER 1-3 buttons.
Note:
BRemote control signals that are not infrared-type (wave format) signals
cannot be recorded.
BIt may not be possible to record some types of signal.
1
Press [SETUP] for 3 seconds or more.
2
Select "USER 1-3" and then press [ENTER].
3
Select "LEARN?" and then press [ENTER].
4 Place the projector's remote control next to the emitter of the
home theatre system device's remote control.
12
(Example: When "USER1" is selected)
Approx. 5 cm
5
Press the button on the projector's remote control that you
would like to record, and then after "LEARNING" is displayed,
press the corresponding button on the home theatre system
device's remote control.
( ) (
Projector's remote Home theatre system
control device's remote control
( Example: When learning the function of the
playback button
✱
If "ERROR" is displayed
Learning could not be carried out correctly. Return to step 5 and repeat the
learning operation.
✱ To record another button, repeat step 5.
To finish, press [SETUP],
and then check operation.
Note:
B If the batteries of the remote control are spent, the signals will not be
recorded correctly.
B Each button must be recorded separately.
B If no operations are carried out for 60 seconds or more during learning, the
setting mode will be cancelled. To carry out learning correctly, repeat the
procedure from step 1.
B When function buttons A/B/C have been learnt, "-A-, -B-, -C-" will be
displayed, and you can edit the characters that are displayed here.
( p.16)
Tips on correct learning
B Do not move the remote control while learning is in progress.
B Place fresh batteries into both the projector's remote control and the other
remote control before starting.
B Avoid carrying out the procedure in places that are exposed to direct sunlight
or lights. (Interference may occur and cause errors in learning.)
B The position of the emitter will vary depending on the shape of the remote
control. Place the projector's remote control correctly in front of the emitter,
and at a distance of 5 cm.
)
After 5 seconds
)
13