Panasonic PT-AE900U Operating Manual page 6

Setting remote control signals for home theatre systems
I Setting home theatre system devices when you do
not know the device code
When recording remote control signals for a home theatre system device when you do not
know the device code for that device, you can use the search function to make the settings.
Search function
The search function transmits a power supply OFF signal, and searches for and sets
compatible device codes.
1
Turn the power on for the home theatre system device that you
would like to set.
2
Press [SETUP] for 3 seconds or more.
3
Select the device to be set and then press [ENTER].
B When "DVD, VCR, AMP" is selected
B When "TV/TNR" is selected
3
Select the device to be
-1
set and then press
[ENTER].
10
4
Continue to step
TV SAT CBL
4
Continue to step
B When "USER 1-3" is selected
3
Press the up or down button to select "SEARCH?"
-1
and then press [ENTER].
✱ If "ERROR" is displayed
The remote control signal that you are trying to learn has
already been registered, so the device code cannot be
selected. To set a device code, clear the remote control signal
that has been learnt. (
3
Select the device to be set and then press [ENTER].
-2
5
Continue to step
4
Press [NORMAL].
5 Point the remote control at the home theatre system device
and press the up button once.
✱ Repeat step 5 until the power turns off for the home theatre system
device.
6
Once the power for the home theatre system device turns off,
press [ENTER].
p.14)
DVD HVAC
VCR TV CBL SAT
(Example: When "DVD" is selected)
To finish, press [SETUP],
and then check operation.
RCV
AMP
11