Receiving A Group Call In Idle Screen With Scan Off; Receiving A Group Call In Idle Screen With Scan On - Motorola TETRA MTH800 Feature User Manual

When receiving a Group call, you will hear a "New Group Call" tone (if
configured by your Service Provider).

Receiving a Group Call in Idle Screen with Scan Off

You can receive a group call from the selected talkgroup or
from the associated ATG only.
Your MTH800 will receive the Group Call.
Receiving a Group Call in Idle Screen with
Scan On
With Scan On, you can receive a group call
from the scan list you set up, in addition to
receiving a group call from the selected
talkgroup or from the associated ATG.
Receiving the scan call functions as receiving
an associated ATG or selected call in scan off
(see previous page), except for the following:
• The display is different when receiving the call in idle
screen, as shown here.
• The terminal sounds a tone as explained in the note
below.
• When receiving a High Priority Group Call, you will hear a "High Priority
Group Call" tone (if configured by your Service Provider).
• When receiving a Group Call from your scan list, which is not from a high
priority group, you will hear a "New Group Call" tone (if configured by your
Service Provider).
• To block reception of a Group Call, select Optns then
Block. Powering off/on the terminal unblocks the recep-
tion of this Group Call.
38
Group In Use
TG4
ID: David
Optns Folder
Group In Use
TG4
ID: David
Optns End