Changing The Handset Name - Panasonic KX-TG8151FX Operating Instructions Manual

2
Select your desired categories by
pressing 1 to 9.
R " " is displayed next to the selected
category numbers.
R To cancel a selected category, press
the same dial key again. " "
disappears.
3
a M N

Changing the handset name

Each handset can be given a customised
name ("Bob", "Kitchen", etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is "No". If you select
"Yes" without entering any handset name,
"Handset 1" to "Handset 6" is displayed.
1
(middle soft key) #104
2
Enter the desired name (max. 10
characters; page 49).
R If not required, go to step 3.
3
4
MbN: Select the desired setting. a
times
5
M N
Incoming call barring (Caller ID
subscribers only)
This feature allows the unit to reject calls from
specified phone numbers that you do not want
to answer such as junk calls.
When a call is received, the unit does not ring
while the caller is being identified. If the phone
number matches an entry in the call barred
list, the unit sends out a busy tone to the
caller, and then disconnects the call.
Important:
R When the unit receives a call from a
number that is stored in the call barred list,
the call is logged in the caller list
(page 37) with after the call is
disconnected.
TG8151_61FX(en)_0323_ver011.pdf
Storing unwanted callers
You can store up to 30 phone numbers in the
call barred list.
Important:
R You must store the phone number with an
area code in the call barred list.
n From the caller list:
1
2
3
4
n By entering phone numbers:
1
2
3
Viewing/editing/erasing bar call
2
numbers
1
2
MbN: Select the desired entry.
R To exit, press M
3
To edit a number:
To erase a number:
Note:
R When editing, press the desired dial key to
add,
Setting call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the restricted
33
Programming
MFN ( )
MbN: Select the entry to be barred. a
a
MbN: "Caller Barred" a
MbN: "Yes" a a M
(middle soft key) #217 a
Enter the phone number (24 digits
max.). a
R To erase a digit, press
M N
(middle soft key) #217
N.
a Edit the phone number. a
a M N
a MbN: "Yes" a
to erase.
2012/03/23 16:35:21
N
.
a M N
33