Call Waiting - Mitsubishi Electric M21i User Manual

Divert
options
To divert all incoming
Always
voice calls.
When
To divert all voice calls
not
when the phone
reacha-
cannot be reached (out
ble
of service).
To divert all voice calls
On no
when the call is not
reply
answered to.
To divert all voice calls
When
when the line is
busy
engaged.
To divert all voice calls
All con-
when Not Reachable,
ditions
No Reply and When
Busy.
Cancel
To cancel all diverting
all
options.
To unconditionally
All FAX
divert incoming fax
calls
calls.
All
To unconditionally
DATA
divert incoming data
calls
calls.
Select one of these options
4
and select OK
Select Activate
5
Select Voice Mail, Names or
6
Number
Enter the number the calls
7
have to be diverted to and
select OK
message bearing the selected
number is displayed.
4
1. If the 'On no reply' option is selected please enter
the time limit (5, 15 or 30 seconds; this also depends
on your network) after which the feature is valid.
2. Call diverts for both Line 1 and Line 2 have to be set
for each line. Only the selected line is affected by the
call divert.
To check the call divert status or de-
activate it:
. Select Settings.
1 Press
Select GSM Services
2
52
Action
.
.
. A validation
.
Select the call diverting type
3
to be checked or
cancelled .
4 Select Status or Cancel
To cancel all (multiple) diverts,
Press . Select Settings.
1
Select GSM Services
2
Select Call diverting
3
Select Cancel all
4
4
1. This action cancels all call diverts (for voice, faxes
and data calls) for the current line.
2. To cancel call diverts for the other line you must
select this other line first (menu Calls & Times - Line
selection).

Call waiting

This network dependent feature al-
lows to receive a new call while a call
is already on (network dependent).
To activate the call waiting feature:
Press . Select Settings.
1
Select GSM Services
2
Select Call waiting
3
Select Activate
4
vated or Check your
request is then displayed.
4
You can also cancel or check the service status.
To put a call on hold and switch from
Call 1 to Call 2:
Whilst on a call a beep sounds
1
to indicate a second incoming
call.
Select Replace to take Call 2
and end Call 1, Select Reject
to refuse Call 2 or press the
key to put Call 1 on hold and
take Call 2.
Select Options then select
2
Swap to get back to Call 1
and put Call 2 on hold or select
Join to have a 3 party conver-
sation.
.
.
.
.
.
.
. Acti-