Call Waiting - Mitsubishi Electric M320 User Manual

Divert
options
Always
When
not
reacha-
ble
On no
reply
When
busy
All con-
ditions
Cancel
all
All FAX
calls
All
DATA
calls
Select one of these options
4
and select OK
Select Activate
5
Select Voice Mail, Names or
6
Number
Enter the number the calls
7
have to be diverted to and
select OK
message bearing the selected
number is displayed.
4
1. If the 'On no reply' option is selected please enter
the time limit (5, 15 or 30 seconds; this also depends
on your network) after which the feature is valid.
2. Call diverts for both Line 1 and Line 2 have to be set
for each line. Only the selected line is affected by the
call divert.
To check the call divert status or deac-
tivate it:
Press
1
Select GSM Services
2
36
Action
To divert all incoming
voice calls.
To divert all voice calls
when the phone
cannot be reached (out
of service).
To divert all voice calls
when the call is not
answered to.
To divert all voice calls
when the line is
engaged.
To divert all voice calls
when Not Reachable,
No Reply and When
Busy.
To cancel all diverting
options.
To unconditionally
divert incoming fax
calls.
To unconditionally
divert incoming data
calls.
.
.
. A validation
. Select Settings.
.
Select the call diverting type
3
to be checked or
cancelled .
Select Status or Cancel
4
To cancel all (multiple) diverts,
Press . Select Settings.
1
Select GSM Services
2
Select Call diverting
3
Select Cancel all
4
4
1. This action cancels all call diverts (for voice, faxes
and data calls) for the current line.
2. To cancel call diverts for the other line you must
select this other line first (menu Calls & Times - Line
selection).

Call waiting

This network dependent feature al-
lows to receive a new call while a call
is already on (please contact your serv-
ice provider for more information).
To activate the call waiting feature:
Press . Select Settings.
1
Select GSM Services
2
Select Call waiting
3
Select Activate
4
vated or Check your
request is then displayed.
4
You can also cancel or check the service status.
Whilst on a call a beep sounds when a
second call comes in.
Select Replace to end Call1 and an-
swer Call2 or select Reject to refuse
Call2 and go on with Call 1.
To put a call on hold and switch from
Call 1 to Call 2:
1 Whilst on a call a beep sounds
to indicate a second incoming
call.
Select Replace to take Call 2
and end Call 1, Select Reject
to refuse Call 2 or press the
key to put Call 1 on hold
and take Call 2.
.
.
.
.
.
.
. Acti-