Advertisement
OPERATION
I
Base
Cutting line
I -
t J
Cutting operation
CAUTION:
Check carefully that the blade is adequately secured in position before inserting the bat-
tery into the tool
Turn the tool on without the blade making
any contact. Rest the base flat on the work-
piece and gently move the tool forward
along the previously marked cutting line.
I
CAUTIO N :
*Always hold the tool with the base flush with the workpiece. Failure to do so may cause
*Advance the tool very slowly when cutting curves or scrolling. Forcing the tool may
a slanted cutting surface and blade breakage.
cause a slanted cutting surface and blade breakage.
Bevel cutting
CAUTION:
Always remove the battery from the tool before making any adjustments
With the base tilted, you can make bevel
I
cuts at any angle between 0" and 45" (left
or right). Loosen the bolt on the bottom of
the tool. Move the base
so
that the bolt is
positioned in the center of the cross-shaped
slot in the base.
I
15
Advertisement
