Advertisement
Tilt the base until the desired bevel anale
I
-
is obtained. The edge of the motor housing
indicates the bevel angle by graduations.
Then tighten the bolt to secure the base.
Flush cutting
Loosen the bolt on the bottom of the tool
and slide the base all the way back. Then
tighten the bolt to secure the base.
F , g e , o f motor housing
,
Graduations
I
I
Base
cutouts
Cutouts can be made with either of two methods A or B.
A)
Boring a starting hole: For internal cut-
outs without lead-in cut from an edge,
pre-drill a starting hole more than
12 mm (15/32") in diameter. Insert the
blade into this hole and hold the tool
firmly against the workpiece to start
your cut.
16
Advertisement
