Quickstart Operating Instructions - Minelab Eureka Gold Instruction Manual

Page 1
6.

QuickStart Operating Instructions

a) Switch On the power with the Volume control.
b) Set the Volume control to maximum.
c) Set the Sensitivity control to maximum.
d) Set the Threshold control so that the audio level is just audible.
e) Set the Tone control to a pitch you find comfortable.
f) Set the Mode switch to All Metal.
g) Set the Signal switch to Normal.
h) The Disc. control is disabled when in All Metal mode.
i) Set the Frequency switch to 6.4kHz for detecting large, deep targets or
60kHz for small shallow targets or 20kHz for general purpose searching.
j) Select the Fast Track (1) for automatic ground balacing in most heavily
mineralised ground conditions (see section 5.6 for more information).
k) Ground balance the detector by raising and lowering the coil just above
the ground in an area free of targets. Correct ground balance is achieved
when there is no change in threshold hum as the coil is raised and
lowered.
l) Start searching.
Minelab recommends that you read this instruction manual in full, so that
you understand the true function and purpose of the controls. This will
allow you to select the control settings for different conditions.
The Minelab Eureka Gold