Registration; Registering A Handset In The Base Unit - Panasonic KX-TCD965EC Operating Instructions Manual

KX-TCD965EC-5(63~73) 99.9.27 7:58 PM

Registration

Registering a Handset in the Base Unit

You must register the handset in the base unit before use.
Charge the optional handset batteries for approximately 4 hours before initial use.
Make sure that the power is ON (p. 14) and the unit is in the stand-by mode.
Register the handset number within 1 minute. If not registered within 1 minute, press
handset to cancel the programming mode. Then start again from step 1.
1
Handset:
Press .
F
Press G or F until the arrow points to
2
"Program", then press
3
Base unit where handset is to be
registered :
Press and hold
for more than 10 seconds until the in
use indicator (
confirmation tone sounds.
4
Handset:
Press G or F until the arrow points to
"Registration", then press
Press G or F until the arrow points to
5
"Register H/set", then press
The available base unit numbers are
displayed.
6 Press G or F to select the desired
base unit number 1 to 4.
The number is assigned as the base unit
number for the handset.
P l e a s e W a i t . . .
E n t e r B a s e P I N
: -
64
Page 64
7
8
OKH .
on the base unit
) lights and a
OKH
.
OKH .
You can exit the programming mode any time
by pressing
The base unit number which the handset is
currently in contact with can be displayed in
the stand-by mode (p. 67). Calls (both
incoming and outgoing) can be conducted only
via the displayed base unit (even if the radio
areas overlap with neighbouring base units).
C
Enter the base unit password (p. 45).
Press OKH .
"Please Wait..." is displayed, then
a confirmation tone sounds.
The handset will return to the stand-by
mode. The current connected base unit
number will be displayed.
0 N e w C a l l s
B a s e 2
The in use indicator ( ) on the base
unit will go out.
To register the handset in more than one
base unit, repeat from step 1 with the
other base unit(s).
C .
on the