Setting The Remote Code - Panasonic KX-TCD965EC Operating Instructions Manual

KX-TCD965EC-4(54~62) 99.9.27 8:00 PM
Remote Operation from a Touch Tone Phone

Setting the Remote Code

The remote code prevents unauthorised people from accessing your unit and listening to your
messages. Choose any 3-digit number (000–999). The remote code is not preset.
Make sure that the power is ON (p. 14) and the unit is in the stand-by mode.
1
Press F .
G G or F F until the arrow points to
2
Press
"Program", then press OKH H .
Press G G or F F until the arrow points to
3
"Setting Base", then press OKH H .
"Input Command" is displayed.
4
Press .
"Remote Operation" is displayed on
the handset.
" P " is displayed on the base unit.
5
1
Press .
6
Enter a remote code using a 3-digit
number (000–999).
The entered number is displayed
on the base unit.
Press OKH H .
7
A confirmation tone sounds.
To change the remote code,
repeat from step1.
If 6 beeps sound in step 7, a 3-digit number
was not entered. Start again from step 1 and
enter a 3-digit number.
If a remote code is not programmed, you
cannot use the unit remotely.
58
Page 58
Cancelling the remote
operation
You can prohibit anyone from accessing to your
unit and listening to your recorded messages
remotely. Erase the remote code in the following
way. After this programming, you cannot use the
remote operation functions (p. 59–61).
1
Press .
F
2 Press G G or F F until the arrow points to
"Program", then press OKH H .
Press G G or F F until the arrow points to
3
"Setting Base", then press OKH H .
"Input Command" is displayed.
4
Press .
"Remote Operation" is displayed on
the handset.
" P " is displayed on the base unit.
5
1
Press .
6
Press .
The display goes out.
Press OKH H .
7
To cancel, reprogram a new remote code.