Table of Contents
Advertisement
KX-TCD965EC-2(26~41)
99.9.27 8:03 PM
Making Calls
Make sure that the power is ON (p. 14).
1
Press
.
"
" is displayed.
2
Dial a phone number.
The dialled number is displayed.
12345678
After a few seconds, the display will start
showing the length of the call.
00-00-00
3
To hang up, press
handset on the base unit.
The handset will return to the stand-by
mode.
To dial after confirming the
entered number
1
Enter a phone number.
The entered number is displayed.
If you misdial, press I. Digits are erased
from the right.
To cancel, press I firmly.
If your line has rotary or pulse service, any
access numbers entered after pressing
will not be included when dialling.
2
Press
.
"
" is displayed.
After a few seconds, the display will start
showing the length of the call.
3
To hang up, press
handset on the base unit.
The handset will return to the stand-by
mode.
26
Page 26
If "
" flashes and an alarm tone sounds
after pressing
base unit. Then try again.
You can choose whether to display the length
of the call or phone number in the talk mode
by programming (p. 51).
To select the receiver volume
3 levels (HIGH, MEDIUM, LOW) are available.
The factory preset is MEDIUM.
While talking, press
desired level.
The display shows the volume level.
Ex. Low is selected.
or place the
R e c e i v e r V o l u m e
LOW
After a few seconds, the display will return to
the length of the call.
OR
In the stand-by mode, proceed as follows.
1
Press
Press G or F until the arrow points to
2
"Program", then press
3
Press G or F until the arrow points to
"Receiver Volume", then press
OKH
4
Press
level.
5
Press OKH.
or place the
The display will return to "Receiver
Volume". To return to the stand-by mode,
press
, move closer to the
F
G
or
to select the
1
HIGH
.
F
OKH
.
.
F
G
or
to select the desired
or wait for 60 seconds.
C
Advertisement
Table of Contents
