Receiving A Call; Dialling A Number - LOGICOM CALIS Manual

2-5 Dialling a number

a) Standard dialling procedure
• The handset is on standby (no call tone).
• Press key
(4)
• The and icons are displayed on-screen and the indicator light
the base switches on.
• You will hear the call tone
• Dial the number of your correspondent
• At the end of the call, press key (4)
b) Predialling
• The handset is on standby (no call tone).
• Dial the number of your correspondent
• The number is displayed on-screen
• Press key (4)
• The and icons are displayed on-screen and the indicator light
the base switches on.
• The number is dialled automatically
• At the end of the call, press button
c) Redial function for the last 10 numbers dialled
• The handset is on standby (no call tone).
• Press key (5)
• The last number called is displayed on-screen
• Use key (5) or (6) to select one of the last 10 numbers dialled.
• Press key
(4)
• The displayed number is dialled automatically
• At the end of the call, press button
14
(14)
or place the handset on the base.
(14)
(4) or place the handset on the base.
(4) or put the handset on the base.

2-6 Receiving a call

a) The handset is not on its base.
• The handset rings (according to settings).
• The icon flashes on the LCD screen
• Press key
(4)
• Speak with your correspondent
on
• When the call is over, press key
b) The handset is on the base.
When the handset is on the base, opening the line depends on the
beforehand.
There are 2 programming modes to determine whether, after lifting the handset from its
base, you must either :
• Press key (4) (AUTO PKUP mode ON)
Or • Do not press key
You must use the following procedure to program one of these modes :
• Press key .
(7)
on
• "PHONE BOOK" is displayed on the LCD
• Press key (6) to select "HANDSET"
• Press key .
(7)
• Press key (6)
• Press key (7) .
• The current setting is displayed on-screen.
• Press key (5) or (6)
ON (the line will be opened for a call when the handset is picked up).
ARRET (la ligne ne sera pas prise au décroché lors d'un appel).
• Press to validate the setting.
(7)
• Press and hold key
N.B. : During this procedure, the previous mode is restored automatically after 60 seconds of
inactivity on the keys.
(4) or place the handset on the base.
(4) (AUTO PKUP mode OFF)
screen.
until "AUTO PKUP" is displayed on-screen.
to select the required mode of operation.
C
(9) to return to standby mode.
programming set
manque
traduction
15