Selecting A Ring Tone For The Base - LOGICOM CALIS Manual

2-19 Selecting a ring tone for the base

Five different ring tones are available for this system.
To select a ring tone, follow these steps :
• The handset is on standby (no call tone).
• Press key (7)
• "PHONE BOOK" is displayed on-screen.
• Use key (6) until "PAUSE" is displayed
• Press key (7)
• Press key (6) until "BASE MEL" is displayed
• Press key (7)
• The ring tone used by the base sounds and is displayed ("MELODY:
• Press key or (6) to select a ring tone.
(5)
• Press key (7) to validate the setting.
C
• Press and hold key (9) for 2 seconds to
N.B. : During this operation, standby mode is automatically
key has been pressed for 60 seconds.
26 26
on-screen.
on-screen.
3" for example).
restore standby mode.
restored to the handset when no
2-20 Setting the ring tone volume on the base
The volume of the ring tone may be set at five levels (1 is the minimum and 5 the
mum). The ring tone on the base may also be switched off (MUTE).
The default volume level is : 4.
To adjust the volume level on the base, follow these steps :
• The handset is on standby (no call tone).
• Press key
(7)
• "PHONE BOOK" is displayed on-screen.
• Use key (6) until "SETTINGS" is displayed
• Press key (7)
• "BASE VOL" is displayed on-screen.
• Press key (7)
• The volume level used is displayed :
• "VOLUME X" (X represents the level between 1 and 5).
Or
• "MUTE" (the ring tone is switched
• Use key (5) and (6) to select the
• Press key (7) to validate the setting.
C
• Press and hold key (9) for 2 seconds to
maxi-
on-screen.
off).
desired ring volume.
restore standby mode.
27