Displaying The Call Duration; Internal Call; Adjusting The Ring Tone Volume On The Handset - LOGICOM CALIS Manual

2-16 Displaying the call duration

The call duration is displayed after 15 seconds.
In minutes-seconds: "00-15".
At the end of each call, the call duration is displayed for 2 seconds.
2-17 Choosing a ring tone on the handset (external and

internal call)

The ring tone for an external call can be different from that of an interphone call.
Choosing a ring tone :
• The handset is on standby (no call tone).
• Press key
(7)
• "PHONE BOOK" is displayed on-screen.
• Press key (6) to select "HANDSET" on the
• Press key (7)
• "BEEP" is displayed on-screen.
• Press key (6) until the following is displayed :
• "INT MEL" to select the ring tone for an
OR
• "EXT MEL" to select the ring tone for an
• Press key
(7)
24 24
screen.
internal call
external call
• The set ring tone sounds and is displayed ("MELODY:
• Press key or (6) to select a ring tone.
(5)
• Press key (7) to validate the setting.
C
• Press and hold key for 2 seconds to
(9)
N.B. : During this operation, the handset automatically
been pressed for 60 seconds.

2-18 Adjusting the ring tone volume on the handset

The ring tone volume on the handset can be set to :
• MUTE (ring tone switched off)
• 5 levels (1 minimum to 5 maximum)
• CRESCENDO (the ringing gradually becomes louder)
The default ring tone volume is : 4.
To set the ring tone volume, follow the steps below :
• The handset is on standby (no call tone).
• Press key
(7)
• "PHONE BOOK" is displayed on-screen.
• Press key (6) to select "HANDSET"
• Press key (7)
• "BEEP" is displayed on-screen.
• Press key (6) until "RING VOL" is displayed
• Press key (7)
• Press key (5) or (6) to select either :
• "MUTE", "CRESCENDO" or "VOLUME X" (X
• Press key (7) to validate the setting.
C
• Press and hold key (9) for 2 seconds to
N.B. : During this operation, the handset automatically
been pressed for 60 seconds.
3" for example).
restore standby mode.
returns to standby when no button has
on-screen.
represents the level between 1 and 5).
restore standby mode.
returns to standby when no button has
25