Figure 2-7 Normal Alarm States; Figure 2-8 Alarm Connection - Honeywell EQUIP HD4HDIH User Manual

Installation and Setup
26
Connecting Audio
Your camera supports bi-directional audio. There are two supported voice band channels
that function in full duplex mode. The camera can transmit audio from the camera to the
client (PC) using any audio source that provides an industry standard line level input (see
the terminal strip as depicted in
client (PC) and provide an industry standard line level output (3.5 mm stereo or mono jack)
suitable to connect to audio devices. Audio input and output have 600 Ohm impedance.
See Audio Settings on page
Connecting Alarms
WARNING! Do not exceed the maximum rating of 12 VDC, 0.5 A on alarm
output connections.
Your camera has one alarm input and one alarm output. Connect mechanical or electrical
switches to the alarm input connection to allow event-triggered recording. When alarm
inputs are configured, the camera triggers an alarm only when the normal alarm state (open
or closed) changes (see Figure
inputs.
Figure 2-7 Normal Alarm States
Normally closed
Connect external devices such as sirens or flashing lights to the alarm output connector to
signal users that an alarm is activated. See
Figure 2-8 Alarm Connection
Audio
The alarm output can be configured to provide normally open or normally closed contacts
(see Alarm Settings on page
12V DC @ 0.5 A.
Figure 2-6). The camera can also receive audio from the
67 to configure audio options.
2-7). See Alarm Settings
Normally opened
Figure 2-8
Alarm
In Out

+
67 to configure the alarm output). Contacts will be rated for
on page 67 to configure the alarm
for alarm connection.
+
–