Installation and Setup
Step 4. Installing the Conduit Plug
Step 5. Installing the Grommet (optional)
22
Your camera enclosure base comes with a conduit plug pre-installed in the 3/4 inch conduit
entry on the back. To use the back conduit entry, remove the conduit plug and install it in
the side conduit entry after loosening the locking screw (see
locking screw to secure the conduit plug in place.
Figure 2-4
Conduit Plug Installation
Back entry conduit
Enclosure base
WARNING!
To minimize moisture leaking into the camera housing when
mounting your camera on a vertical surface, position the
enclosure with the side conduit entry pointing down. After
feeding the cables through (see
Wiring, page 23), apply an appropriate sealant around the
conduit connection.
If a conduit is not used for cable routing, install the rubber grommet in the conduit hole (in
the camera base), then slit the grommet and feed the cables through (see
Connecting the
Wiring, page 23). Use the appropriate sealant to seal the grommet to
prevent moisture from entering the housing.
Figure
Rubber washer
Screw
Conduit plug locking screw
Side entry conduit
Conduit plug
Step 7. Connecting the
2-4). Retighten the
Step 7.