Emptying The Waste Containers - Konica Minolta BIZHUB C450P User Manual

8

Emptying the waste containers

If the hole-punch waste container in punch kit installed on Finisher FS-603
becomes full, the message shown below appears (if it can be emptied by the
user).
Note
No message appears if the hole-punch waste container in Finisher
FS-507 becomes full.
Periodically check the volume of the contents of the hole-punch waste
container.
When the message "Punch Scrap Full Call Service." appears, contact the
service representative.
The setting for the message contents for emptying the hole-punch waste
container must be specified by the service representative. For details,
contact the service representative.
!
Detail
If the hole-punch waste container becomes full, printing cannot be
performed with a Punch setting. To continue printing, empty the hole-
punch waste container or cancel the Punch setting.
8-6
Maintenance
bizhub C450P (Phase 3)