Setting Up The System - Konica Minolta BIZHUB C450P User Manual

Setting up the printer driver

Setting up the system

In order to use this printing system, it must first be set up.
Setup consists of connecting this machine to a computer and installing the
printer driver onto the computer being used.
Setup the printing system as described below.
1
Connect this machine to a computer. (Refer to "Connecting to a
computer" on page 2-39.)
2
Install the printer driver. (Refer to "Installing the printer driver" on
page 3-6.)
– Installation of the printer driver may differ depending on the
connection method used with this machine in addition to the
operating system of the computer and the type of printer driver
being used.
– To update an existing printer driver, delete the existing printer driver
first. For details, refer to "Uninstalling the printer driver" on
page 3-18.
3
When using a network connection, set up the network. (Refer to
"Setting up network printing" on page 3-30.)
– As necessary, set the interface timeout settings and parallel
interface mode (Compatible, Nibble, or ECP) in the I/F Setting menu
from the control panel. When using a parallel or USB port, you must
select the port being used. For details, refer to "Admin. Setting" on
page 5-40.
4
Check the setup by printing a test page. (Refer to "Test printing" on
page 3-28.)
5
Install the screen fonts.
– The User Software CD-ROM and PostScript Printer Driver CD-ROM
contain the Latin TrueType fonts as the screen fonts.
– Install the screen fronts after adding the operating system standard
fonts. For details, refer to Help of the operating system.
– The screen fonts are located in the Screenfont or Screenfonts folder
on the CD-ROM.
– To install the Macintosh fonts, install the fonts after decompressing
them.
bizhub C450P (Phase 3)
3
3-5