Table of Contents
Advertisement
When a Message Appears
Symptom
The copy has dark specks or
spots.
The copy has lines.
The image on the copy is not
aligned properly.
The printed page is curled.
7416CG
Possible Cause
The Original Glass surface is
dirty.
The Original Pad is dirty.
The original is highly
transparent.
The original is 2-sided.
Something is sticking to the
Original Glass (when the
Auto Document Feeder is
used).
The Drum Cartridge has
reached the end of its
service life.
The original is not placed in
the correct position.
The original may not be
suitable for use in the Auto
Document Feeder.
The Edge Guide and Trailing
Edge Stop are not pressed
up against the paper stack in
the tray.
The paper has an excessive
curl.
The paper that was used
curls easily (as with recycled
paper).
Action
Wipe the Original Glass
clean with a soft, dry cloth.
Wipe the Original Pad clean
with a soft cloth dampened
with neutral detergent.
Place a blank sheet of paper
over the original.
If a thin double-sided
document is being copied,
the information on the back
side may be reproduced in
the copy. Press the [ ] key
Ö
and select a lighter copy
density.
Wipe the Original Glass
clean with a soft, dry cloth.
Contact your service
representative.
Place the original correctly
on the Original Glass against
the Original Scales.
Or, load it in the Auto
Document Feeder correctly
along the Document Guide
Plates.
Raise the Auto Document
Feeder and place the original
on the Original Glass
correctly against the Original
Scales.
Slide the Edge Guide and
Trailing Edge Stop up
against the edges of the
paper stack.
Smooth out curls in the
paper and reload the paper
stack in the tray.
Remove the paper from the
paper tray, turn it over, and
then load it again.
Change the paper.
6-21
6
Advertisement
Table of Contents
