Direct Commands For Programming Features - Panasonic KX-FT932FX Operating Instructions Manual

L This feature is not valid if you select "PHOTO"
resolution for sending (page 20) or copying (page 27)
a document.
Code #59: Setting the print contrast
PRINT CONTRAST
=NORMAL [±]
To adjust the darkness of received or copied documents.
"NORMAL" (default): Normal contrast.
"DARKER": Darker contrast.
Code #67: Setting the incoming message monitor
(KX-FT938 only)
ICM MONITOR
=ON [±]
To select whether the greeting message is heard
through the unit's speaker when the unit answers a call.
"ON" (default): You can monitor the incoming message.
"OFF": Deactivates this feature.
Code #70: Calling your pager (KX-FT938 only)
PAGER CALL
=OFF [±]
See page 31 for details.
Code #73: Changing the receiving mode in the
manual answer setting
MANUAL ANSWER
=TEL [±]
"TEL" (default): Telephone mode (page 24)
"TEL/FAX": Telephone/Fax mode (page 25)
Code #76: Setting the connecting tone
CONNECTING TONE
=ON [±]
If you often have trouble when sending faxes, this feature
allows you to hear connecting tones: fax tone, ring back
tone and busy tone. You can use these tones to confirm
the status of the other party's machine.
"ON" (default): You will hear connecting tones.
"OFF": Deactivates this feature.
Note:
L If the ring back tone continues, the other party's
machine may not be a fax machine or may have run
out of paper. Check with the other party.
L The connecting tone volume cannot be adjusted.
Code #77: Changing the receiving mode in the auto
answer setting (KX-FT938 only)
AUTO ANSWER
=TAM/FAX [±]
"TAM/FAX" (default): Telephone Answering
Machine/Fax mode (page 25)
"FAX ONLY": FAX only mode (page 26)
8. Programmable Features
Code #78: Changing the TEL/FAX delayed ring
setting
TEL/FAX RING
RINGS=2 [±]
If you use an extension telephone in TEL/FAX mode,
select the desired number of times the extension
telephone rings before the unit answers the call. You can
select "1", "2" (default), "3", "4", "5", "6", "7", "8" or
"9". See page 25 for details.
Code #80: Resetting advanced features to their
default settings
SET DEFAULT
RESET=NO [±]
To reset the advanced features:
1. Press {MENU}.
2. Press {#}, then {8}{0}.
3. Press {A} or {B} repeatedly to select "YES".
4. Press {SET}.
5. Press {SET} again.
6. Press {MENU}.
8.4 Direct commands for
programming features
You can also select the desired setting by directly
entering the program code (# and a 2-digit number) and
direct command.
For more details on the features, see page 32 to page
35.
1
Press {MENU}.
2
Press {#} and the 2-digit code number.
3
Press the desired direct command to display the
desired setting.
L This step may be slightly different depending on
the feature.
4
Press {SET}.
5
To exit programming, press {MENU}.
8.4.1 Program code and direct command
button
{#}{0}{1} Date and time
L Enter the date and time using the dial keypad. See
page 11 for details.
{#}{0}{2} Your logo
L Enter your logo using the dial keypad. See page 12
for details.
{#}{0}{3} Your fax number
L Enter your fax number using the dial keypad. See
page 13 for details.
35