Power Supply; Charging Time And Available Recording Time - Panasonic NV-DS88EN Operating Instructions Manual

1
2
1
2
PUSH
BATT
NV-DS88
A
B
1 h 40 min. (1 h 20 min.)
C
50 min. (40 min.)
A
1 h 50 min.
B
2 h 55 min. (2 h 25 min.)
C
1 h 30 min. (1 h 15 min.)
A
B
3 h 30 min. (2 h 50 min.)
C
1 h 45 min. (1 h 25 min.)
A
3 h 15 min.
B
6 h 05 min. (5 h.)
C
3 h 05 min. (2 h 30 min.)
A
5 h 20 min.
B
11 h 30 min. (9 h 25 min.)
C
5 h 45 min. (4 h 45 min.)
60

Power Supply

ª Using the AC Adaptor
1
2
1
3
3
ª Using the Battery
Before use, fully charge the Battery.
1
2
Disconnecting the Power Source
2
Set the [OFF/ON/MODE] Switch
[PUSH BATT] Button
it.
1
ª Using the Car Battery Charger
MODE MODE
ON ON
OFF OFF
If you use the Car Battery Charger (VW-KBD2E; optional), you can supply
power to the Movie Camera and charge the battery inside your car. For
further information, refer to the instruction manual of the Car Battery Charger.
≥Be sure to start the car engine before you connect the Car Adaptor Cord,
otherwise the fuse may blow.
≥For other notes concerning this item, see page 92.

Charging Time and Available Recording Time

A
1 h.
B
C
(Intermittent Recording Time is the available recording time with repeated
recording and stopping actions.)
≥"1h10min." indicates 1 hour and 10 minutes.
≥Battery CGR-D08R is supplied.
≥The times shown in the table are approximate times. The numbers in
2 h.
parentheses indicate the recording time when the LCD Monitor is used. In
actual use, the available recording time may be shorter.
≥The times shown in the table are for continuous recording at a temperature
of 20oC and humidity of 60%. If the Battery is charged at a higher or lower
temperature, the charging time may be longer.
Connect the DC Input Lead to the Movie Camera.
Connect the DC Input Lead to the AC Adaptor.
Connect the AC Mains Lead to the AC Adaptor and the AC
mains socket.
≥The AC Mains Lead's outlet plug cannot be pushed fully into the AC
Adaptor socket. A gap will remain as shown
≥Before disconnecting the power supply, set the [OFF/ON/MODE]
Switch on the Movie Camera to [OFF].
Attach the Battery to AC Adaptor and charge it.
≥Since the Battery will not be charged when the DC Input Lead is
connected to the AC Adaptor, disconnect them.
≥The [POWER] Lamp and [CHARGE] Lamp lights up, and charging
starts.
≥When the [CHARGE] Lamp goes off, charging is completed.
Attach the charged Battery to the Movie Camera.
2
, slide the Battery or DC Cable upward to disconnect
~~~~~~~~~~~~~~~~~~~~~~~~
Charging Time
Maximum Continuous Recording Time
Intermittent Recording Time
1
.
1
to [OFF] and, while pressing the