Konica Minolta 7255 Instruction Manual page 250

Repeating Automatically Or Selecting Repeating Times(Repeat: AUTO/
5.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
6.
Select the desired magnification and paper size.
• APS and AMS are automatically released, and 1.00 (100%) is
• When 2 Repeat, 4 Repeat, or 8 Repeat is selected, the scanning area
• Copy mode is automatically set to 1-1. When selecting 1-2 mode,
7.
Enter the desired print quantity from the control panel keypad.
See p. 3-6 for details on setting print quantity.
8.
Position original.
For AUTO mode original, open the document feeder, then position the
original FACE DOWN on the platen glass.
For 2 Repeat, 4 Repeat or 8 Repeat mode original, RADF is also available.
See the illustration on p. 9-36 for details.
When AUTO mode is selected, Non-Image Area Erase functions
automatically.
DO NOT close the document feeder.
9.
Press [START].
When the finisher / shift tray / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
The AUTO mode may not operate properly if the lighting in the work
place is directly over the platen glass. In this case, consult your service
representative about an appropriate place for installation.
9-38
FOR DETAILS
selected as a magnification ratio.
will be a portion of the selected paper size equally divided according
to the selected mode.
In this case, magnification ratio will be fixed to 1.00 (100%).
Platen store mode will function automatically.
HINT
HINT
Please Be Reminded!
CAUTION
FOR DETAILS
Repeat Mode) (continued)