Konica Minolta 7115 User Manual page 38

Konica7115_7118.book Page 13 Tuesday, October 16, 2001 10:51 AM
Before Making Copies
No.
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
Part Name Description
ERASE • Press to select the erase position.
OUTPUT • Press to select the output function.
IMAGE SHIFT • Press to select the Image Shift mode.
X/Y ZOOM • Press to make a copy with different zoom ratios set for
X (horizontal) and Y (vertical) directions.
JOB RECALL • Press to recall either one of the two jobs previously
stored in memory.
BYPASS TRAY • Press to select the size of the paper loaded in the
Bypass Tray.
ZOOM • Press to change the zoom ratio in the range between
50% and 200% in 1% increments.
• What is shown on the Display changes from the number
of copies to be made to the zoom ratio.
DISPLAY • Shows the number of copies to be made, the zoom
ratio, and other setting data.
KEY PAD • Use to type in the number of copies to be made and any
other numeric data.
ID • Press when entering an account number.
• Becomes valid only when Copy Track has been set.
POWER SAVE • Press to set the copier into the Power Save mode.
INTERRUPT • Press to interrupt a copy job.
AUTO RESET • Press to reset all copy functions and settings to their
defaults.
• Holding down the key for 3 seconds or more will set the
copier into the Utility mode.
CLEAR • Press to reset the number of copies to "1."
STOP • Press to stop a print cycle.
• Press to stop a scanning sequence.
START • Press to start a scanning sequence.
• Press to start a print cycle.
• Press to validate the setting just made.
• The key lights up green when the copier is ready to
make copies, orange when it is not ready to make
copies.
ENTER • Press to validate the setting just made.
RE • Press to select a zoom ratio from among those fixed
ratios available as standard.
APS/AMS • Press to select either APS or AMS.
PAPER SIZE • Press to select the paper size
DENSITY SET • Press to adjust the image density of the copy.
3
.
3-13