Setting Date And Time - Panasonic HDC-SD1 Operating Instructions Manual

Setup

Setting date and time

When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥Move the cursor button up or down to select
[YES], press the centre of the cursor button and
then perform steps 2 and 3 below to set the
date and time.
If the screen shows the incorrect date and time,
then adjust it.
Rotate the mode dial to select
¬
1
Press the MENU button, then
select [BASIC]
[YES] and press the cursor
button.
2
Move the cursor button left or
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.
≥The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥The 24-hour system is used to display the
time.
3
Press the cursor button to enter
the selection.
≥The clock function starts at [00] seconds
when the cursor button is pressed.
≥After pressing the MENU button to finish
the setting, check the date and time
display.
38
VQT1D38
.
[CLOCK SET]
#
Changing the date and time display style
Press the MENU button, then select [SETUP] #
[DATE/TIME] # desired display style and press
the cursor button.
≥You can also show or change the date and time
display by repeatedly pressing the DATE/TIME
button on the remote control.
[DATE]
15.12.2007
[OFF]
#
Changing the display style
Press the MENU button, then select [SETUP] #
[DATE FORMAT] # desired display style and
press the cursor button.
Display style
[Y/M/D]
[M/D/Y]
[D/M/Y]
≥The date and time function are driven by a
built-in lithium battery.
≥Make sure to check the time before recording.
≥If the time display becomes [- -], the built-in
lithium battery has run down. Use the following
steps to charge the battery. When you turn on
the power for the first time after charging, a
message asking you to set the date and time
will appear. Select [YES] and set the date and
time.
[D/T]
15.12.2007 15:30
Screen display
2007.12.15
12 15 2007
15.12.2007