Table of Contents
Advertisement
Plug-in Auto Tuning
After pressing [] to turn the unit on for the fi rst time, the unit
starts necessary setup.
If the setup screen does not appear, press [DRIVE SELECT],
and turn the power off and on again.
Included parts to be used
Remote control
Preparation
Insert the included batteries into the remote
control.
Insert so the poles ( and ) match those in the remote control.
POWER /I
CH
DRIVE SELECT
Numbered
buttons
CANCEL
, , ,
ENTER
REC
SFC/EQ
SRD MUSIC
Regarding DST (Daylight Saving Time) (page 15)
Legal revision is expected to change the DST period in 2007.
When you use the unit with DST on, the change may cause the
unit's clock to go behind the actual time. Check the DST setting in
"Set Clock Manually" in the Setup menu, set DST off and reset the
clock precisely if you are using this function.
2 Batteries
R6/LR6, AA
Remote control signal sensor
THEATER
TV
TV operation
buttons
CH
RETURN
SETUP
ADD/DLT
12
Turn on the television and select the
1
appropriate video input to suit the
connections to this unit.
Press [THEATER] to switch the remote
2
control to operate this unit.
Press [].
Select Language
Seleccione el idioma
Sélection de Langue
English
Español
Français
Press ENTER
Pulse ENTER
Appuyer sur ENTER
Press [, ] to select the language and
press [ENTER].
If you make a mistake, press [RETURN] to return to an earlier screen.
Aspect Ratio Selection
Select TV type and press ENTER.
(Please refer to Operation Instruction
for details)
4:3
4:3 TV
16:9
16:9 Widescreen TV
Press [, ] to select the aspect ratio that
fi ts your television best ("4:3 TV" or "16:9
Widescreen TV"), and then press [ENTER].
Quick Start setting
The unit can be turned on faster, in about
1 second. Please note that Quick Start
mode slightly increases power
consumption when the unit is off.
(See Operation Instructions for details)
Turn Quick Start on ?
On
Off
Press [, ] to select "On" or "Off" and
press [ENTER].
If you activate "Quick Start" function, select "On".
About "Quick Start" function
If you set Quick Start to on, you can start recording to DVD-
RAM about 1 second after you press [] to turn the unit on
and then sequentially press [ REC].
The following happens when you have selected "On".
Power consumption in standby mode increases because
power is supplied to the unit.
Default Recording Source
Please select the source from which this
unit will record each time it is turned
on. Note: Selecting "Internal TV Tuner"
will start the Auto Channel Clock
Settings process.
This one time process takes a few minutes.
Internal TV Tuner
Input
Press [, ] to select "Internal TV
Tuner" or "Input" and press [ENTER].
When you do not set channels on this unit, select "Input". The
unit then displays "Set Clock Manually" screen. Set the clock
manually ( page 15).
(Continued on next page)
Advertisement
Table of Contents
