Step 6 Plug-In Auto Tuning - Panasonic SC-HT822 Operating Instructions Manual

6
STEP Plug-in Auto Tuning
TV
INPUT SELECTOR
DVD/VHS FM/AM
DVD VHS TV TUNER
VHS
DISC 1 DISC 2 DISC 3
1 2 3
DISC 4 DISC 5
4 5 6
PICTURE MODE
VOLUME
7 8 9
ENTER
SETUP
S10
100 0
SKIP SLOW/SEARCH
JET REW CD MODE
OPEN/CLOSE/EJECT
TOP MENU
NAVI
DIRECT
NAVIGATOR
ENTER
OSD/
DISPLAY RETURN
TV VOL TV VOL
RESET PAGE MIX 2CH
TV/VIDEO GROUP SUBTITLE PLAY MODE
MULTI RE-MASTER C.S.M C.FOCUS PROGRESSIVE
SUBWOOFER LEVEL SFC SUPER SRND
POSITION
MEMORY ZOOM QUICK REPLAY
PROG SPEED
SLEEP
SHIFT
PL AUDIO CH SELECT
CANCEL
/ I POWER
1 2 3 4 5
DISC CHANGE
DISC
OPEN/CLOSE
POWER
Í /I
DISC CHECK
INPUT
SELECTOR
DISC
5
4
3
STOP PLAY
2
1
- DEMO
DVD/VHS
CH
MENU
MENU
PLAY
LIST
REPEAT
MUTING
REC
TEST
CH CH
EJECT
CH
VOLUME REC
/REW FF/
STOP PLAY
UP
PHONES DOWN
After plugging the unit into your household AC outlet and pressing
[Í] to turn the unit on for the first time, the unit automatically tunes
in all the channels it can receive and sets the clock.
The unit determines the type of transmission, TV or CATV, as
follows:
TV: when there are less than 5 CATV channels.
CATV: when there are 5 or more CATV channels.
Preparation
≥Confirm that the antenna is connected correctly.
≥Turn on the television and select the video input for the VHS.
≥Press [VHS] to put the remote control in VHS mode.
Press [Í] to turn on the unit.
Plug-in Auto Tuning starts and the unit puts the stations it can
receive into channels (➜ page 41, Channel range).
2
AUTO CHANNEL SET
PROCEEDING
END :MENU
The unit starts auto clock setting when finished, then displays the
time.
[Note]
If auto tuning stops partway (by changing the source, turning the
unit off, or due to a power failure.)
1 Disconnect the AC power supply cord on the main unit and then
reconnect it.
2 Turn on the main unit.
To cancel partway
Press [MENU].
∫ To start Plug-in Auto Tuning again (after
relocation, for example)
Preparation
≥Press [Í] to turn on the unit.
≥Make sure there is no video cassette tape loaded in the unit.
≥Press [DVD/VHS] to select "VHS" as the source.
1 Press and hold [W CH] and [X CH] on the main unit
simultaneously for 3 seconds until the channel changes to "2".
Disappears
2 Disconnect the AC power supply cord on the main unit and then
reconnect it.
3 Turn on the main unit. Plug-in Auto Tuning restarts.
Antenna system and channel captions all revert to the
default values when you perform the procedure above.
Reset the timer recording settings. (If necessary reset the
clock first. ➜ page 40, CLOCK SET)
∫ To set the channels manually (➜ page 41).
∫ If the unit couldn't set the clock automatically
The MANUAL CLOCK SET screen appears. Set the time manually
(➜ page 40).
2
RQT7708
17