IPSec VPN Wizard Command
vpn ipsec wizard configure <Gateway | VPN_Client>
This command configures the IPSec VPN wizard for a gateway-to-gateway or
gateway-to-VPN client connection. After you have issued the vpn ipsec wizard
configure command to specify the type of peer for which you want to configure the wizard,
you enter the vpn-config [wizard] mode, and then you can configure one keyword and
associated parameter or associated keyword or associated keyword at a time in the order
that you prefer.
Step 1
Format
Mode
Step 2
Format
Mode
Keyword
ip_version
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
vpn ipsec wizard configure {Gateway | VPN_Client}
vpn
ip_version {IPv4 | IPv6}
conn_name <name>
preshared_key <key>
local_wan_interface {WAN1 | WAN2 | WAN3 | WAN4}
enable_rollover {N | Y {rollover_gateway {WAN1 | WAN2 | WAN3 |
WAN4})
remote_wan_ipaddress {<ipaddress> | <ipv6-address> |
<domain name>}
local_wan_ipaddress {<ipaddress> | <ipv6-address> |
<domain name>}
remote_lan_ipaddress <ipaddress>
remote_lan_net_mask <subnet mask>
remote_lan_ipv6address <ipv6-address>
remote_lan_prefixLength <prefix length>
vpn-config [wizard]
Associated Keyword to
Select or Parameter to Type
IPv4 or IPv6
VPN Mode Configuration Commands
Description
Specifies the IP address version for both the
local and remote endpoints:
• IPv4. Both endpoints use IPv4 addresses.
For the remote LAN IP address, you need to
issue the remote_lan_ipaddress and
remote_lan_netMask keywords and
specify the associated parameters.
• IPv6. Both endpoints use IPv6 addresses.
For the remote LAN IP address, you need to
issue the remote_lan_ipv6address and
remote_lan_prefixLength keywords
and specify the associated parameters.
208