To Test The Aims Control Handset; Oven Thermocouple - AGA AIMS EC Owner's Manual

Fig. 3
Press the fan button on the handset, the vent fan symbol should show on the handset screen.
The oven vent fan should operate and the fan oven neon on the control panel should illuminate.
Press the fan button again and the fan should go off.
In the event of the handset not communicating with the base unit refer to page 22 of these instructions "Handset to base
unit signal check"
Fig. 4

TO TEST THE AIMS CONTROL HANDSET

OVEN THERMOCOUPLE

NOTE: On AIMS controlled cookers the thermostat phial (probe) has been
replaced by an oven thermocouple sensor, which is fitted to the PCB on the
controls chassis (See Fig. 2).
1. Feed the thermocouple sensor through the guide tube into the Roasting
oven.
2. Fit the thermocouple sensor to the support plate so that the sensing tip is
as shown in (Fig. 4). DO NOT OVERTIGHTEN the clamp as this may
damage the sensor. Screw support plate to top of roasting oven.
3. When assembling the controls chassis to the burner housing:-
Ensure that the thermocouple sensor goes through the notch in the top
rear of the panel, and that the sealed pot is below the notch (i.e. sealed
pot must not be trapped between mounting chassis and mesh shield).
7
DESN 515291
DESN 515277 A