Control Panel And Doors - AGA Falcon PROFESSIONAL 110 Gas User's Manual And Installation Instructions

When reassembling the Wok burner, turn over
the large base ring and find the 'D' shaped area.
burner base
Turn the head until the 'D' matches the one on
the burner base. Turn the head over and place it
on the burner base. To fit the small inner burner,
find the larger electrode notch in the burner rim.
Line this up with the white ignition electrode and
place the inner burner on the large base ring.
A electrode notch
Now fit the two trim rings, making sure that they
are sitting down properly.
Griddle
Always clean the griddle after use. Allow to cool
completely before removing. Immerse the griddle
plate in hot soapy water. Use a soft cloth or, for
stubborn stains, a nylon washing up brush.
NEVER USE CAUSTIC OR ABRASIVE
CLEANERS AS THESE WILL DAMAGE THE
SURFACE.
Grill
The grill pan and grid should be washed in hot
soapy water. After grilling meats or any foods
that soil, leave to soak for a few minutes in the
sink immediately after use. Stubborn particles
may be removed from the grid by using a nylon
brush.
underside of burner head
B ignition electrode

Control Panel and Doors

Avoid using any abrasive cleaners including
cream cleaners, e.g. Jif, on brushed Stainless
Steel surfaces. For best results use a liquid
detergent.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean
hot soapy water - but take care that no surplus
water seeps into the appliance. Wipe with a
clean dampened cloth then polish with a dry
cloth. The oven doors should only be cleaned
with a soft cloth wrung out in clean hot soapy
water.
Stainless Steel Cookers with window doors
If the inside face of the glass on window door
model becomes marked, the oven door front
panel can be taken off so that the glass panels
can be cleaned.
Move the cooker forward to gain access to the
sides (see the 'Moving the cooker' section of
these instructions).
Open the oven door slightly and remove the front
panel fixing screws from the door sides (two
each side).
Carefully lift off the outer door panel. The inside
face of the glass panels can now be cleaned -
take care not to disturb or wet the door
insulation. Please note that the door is triple
glazed but the inner two panels are fixed and
should not be separated. After cleaning carefully
refit the outer door panel and replace the side
fixing screws.
15
Australia
stainless steel window doors only