English - Kenwood AT320 User Manual

Use the multi-mill to mill such things
as spices, herbs, nuts, baby food,
salad dressings, cooked fruit,
biscuits, bread and coffee beans.
before using your Kenwood
attachment
G
Read these instructions carefully and
retain for future reference.
G
Remove all packaging and any
labels.
safety
G
Don't touch the sharp blades. Keep
the blade unit away from children.
G
Only use the jar and the blade unit
with the base supplied.
G
Never blend hot liquids in the multi-
mill.
G
Never remove the multi-mill until the
blades have completely stopped.
G
Never attempt to fit the blade unit to
the machine without the jar fitted.
G
Switch off and unplug:
before fitting or removing parts
G G
after use
G G
before cleaning.
G G
G
Never use a damaged machine. Get
it checked or repaired: see 'service'.
G
Never leave the appliance
unattended when it is operating.
G
Never run the multi-mill for longer
than two minutes - it will overheat.
G
Switch off as soon as you have the
right consistency. Spices take less
than one minute.
G
Don't mill turmeric - it's too hard.
G
Break ginger up before milling.
G
Do not let infirm people use the
appliance without supervision.

English

G
Do not let children use or play with the
appliance/attachment.
G
Only use the appliance/attachment for
its intended domestic use. Kenwood
will not accept any liability if the
appliance/attachment is subject to
improper use, or failure to comply with
these instructions.
before use
Wash the parts: see 'cleaning'
key
base
rubber seal
blade unit
milling jar
assembled multi-mill
storage jar and lid (4 supplied)
to use the multi-mill
1 Put your ingredients into the jar.
Don't fill above the maximum level
indicated on the jar.
2 Ensure the rubber seal is snugly in
place on blade unit.
3 Turn the blade unit upside down.
Lower it into the jar, blades down.
4 Screw the base onto the jar until it's
finger-tight.
5 Remove the high speed outlet
cover
6 Place the multi-mill over the outlet,
turn clockwise and at the same time
push down until the attachment
engages
clockwise until the unit locks into
position.
7 Switch on to maximum speed.
2
.
. Then turn further