Upgrading Main Program Via Tftp - Huawei Quidway R2600 Series Installation Manual

Installation Manual
Quidway R2600/3600 Series Modular Routers
Please waiting, it needs a long time (about 1 min).
Write Flash Success.
Please return to 9600 bps. Press ENTER key to reboot the system.
II. Upgrading BOOTROM
Step 1: Attach a terminal or a PC (For a PC, it is necessary to run a terminal emulation
program) to the console of the router. Power on the router for self-check. When the
interface of the terminal running emulation program displays "Quidway start booting",
press <Ctrl+D> and the system will prompt you to enter the BOOTROM password, as
shown below:
Please input bootrom password:
Step 2: Enter correct password. (By default, there is no BOOTROM password. If the
router has been configured with password, please enter the correct password.) Then
the system displays the following menu:
Boot Menu:
1: Download Bootrom program
2: Modify Bootrom password
3: Reboot
Enter your choice (1-3): 1
Step 3: Enter <1>, select to download BOOTROM program, and the subsequent steps
are the same as that in "6.1.2 Upgrading main program".

6.1.3 Upgrading Main Program via TFTP

Note:
While upgrading the main program via TFTP, you need to use the Ethernet interface. For cable connection
method, refer to Chapter 8 Function Modules.
Step 1: Select the Ethernet interface for downloading.
R2600/3600 series support loading application program via a specified Ethernet
interface:
R2630, R2631, R2620 and R2621: Ethernet 0.
R3640 and R3640E: search for 1FE board in the order of slots 0, 2, 1, and 3 until
an Ethernet interface is found, and this interface will serve as the download
Ethernet interface. If there is no 1FE, then search for 2FE board in the same order,
and Interface 0 of the first 2FE found will serve as the Ethernet interface for
downloading.
R3680 and R3680E: search for 1FE board in the order of slots 0, 2, 4, 6, 1, 3, 5,
and 7 until an Ethernet interface is found, and this interface will serve as the
download Ethernet interface. If there is no 1FE, then search for 2FE board in the
same order, and Interface 0 of the first 2FE found will serve as the Ethernet
interface for downloading.
After specifying the Ethernet interface, connect the interface to a PC (suppose its IP
address is 10.110.10.13) via Ethernet cable. Attach a PC (can be the same PC) to the
console of the router.
Step 2: Run the TFTP Server program on the PC connected with the Ethernet, and
specify the directory for the program.
6-4
Chapter 6
Maintenance