Maytag MGD7000AG1 Installation Instructions Manual page 20

Reinstall hinge and latch on
opposite sides
Using a TORX ® T25 ® screwdriver, reinstall the latch plate and
latch backing plate with the 3 TORX ® screws removed earlier
and the hinge assembly with the 5 screws on the opposite
sides from which they were removed.
6, Reinstall inner door assembly
Bottom
of door
Position the door with the inside of the door facing up.
Reinstall the 10 screws securing the inner door to the
outer door.
Using a TORX ® T25 ® screwdriver, remove the 4 screws on the
dryer. Insert the tabs on the hinge into the mounting slot and
slide down to engage the top tab. Secure in place with
the 4 TORX ® T25 ® screws removed earlier.
Reverse door swing square-shaped door
1, Remove door from dryer
Using a TORX® T25 ® screwdriver, remove the 4 screws
securing the door hinge to the dryer and lift up and out to
remove the door. Place the door on a soft towel or other
non-scratch surface. Retain or set aside the 4 screws.
20