Maytag MGD7000AG1 Installation Instructions Manual page 13

Attach 2 ft (0.6 m)inlet h ose tocold water f aucet. Screw on
coupling b yhand until i tisseated o nfaucet. Then attach "Y"
connector tomale endofthe2ft (0.6 m)inlet h ose. Screw on
coupling b yhand until i tisseated o nconnector.
Attach long hose to dryer fill valve
and tighten coupling
Remove protective cap from
water inlet valve. Attach other end
of long hose to fill valve at bottom of dryer
back panel. Screw on coupling by hand until it is seated on
fill valve connector. Using pliers, tighten the couplings an
additional two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling
can result.
Using pliers, tighten the couplings with additional two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.
connector and tighten couplings
Check that the water faucets are turned on.
Attach one of the 5 ft (1.5 m) inlet hose ends to the "Y"
connector. Attach washer cold inlet hose to other side of
"Y" connector. Screw on coupling by hand until it is seated
on connector. Using pliers, tighten the couplings an additional
two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.
Check for leaks around "Y" connector, faucet, and hoses.
13