Note On Remote Readings; Note On °C And °F; Maximum And Minimum Temperatures & Humidities - Oregon Scientific BAA913HG User Manual

Note: The daily alarm will NOT function until the next day if the
pre-alarm has been triggered beforehand. Deactivation of the alarm
function will disable the pre-alarm feature automatically.
CHECKING INDOOR AND REMOTE
TEMPERATURES & HUMIDITIES
To display the indoor and outdoor temperature and humidity
readings, press the CHANNEL button to toggle among the indoor,
Channel 1, 2 and 3 displays.
The temperature can be shown in Centigrade (°C) or Fahrenheit
(°F). Select the appropriate reading by using the °C/°F slide switch
(located in the battery compartment). Slide the switch to °C for
Centigrade or °F for Fahrenheit.
This unit has an auto-scan function that can sequentially display
the indoor and remote readings.
To activate this function, press and hold the CHANNEL button for
3 seconds. To deactivate press the CHANNEL button again.
If the reading goes above or below the specified amounts, the
display will show a flashing "HHH" or "LLL".

NOTE ON REMOTE READINGS

Once batteries are in place in the remote unit, it will start
transmitting samplings at 40 second intervals.
If no signals are received when the remote sensor display is selected,
" " will be displayed. To force the main unit to search for
remote sensor signals, press MEMORY and CHANNEL
simultaneously.
913hg-e.p65
If that fails, check that the remote sensor is still in place. Make sure
the transmission is within range and the path is clear of obstacles
and interference.
Repeat this procedure whenever you find discrepancies between
the display on the main unit and the display on the remote sensor.
The outdoor temperature display on the main unit is dominated by
the selection on the °C/°F slide switch of the main unit. Whatever
the display unit of the remote sensor is, it will only apply to the
remote sensor itself and the temperature will be automatically
converted to the chosen one of the main unit.
The maximum and minimum recorded temperatures and humidities
will be automatically stored in memory. To display them, press
MEMORY. Press MEMORY again to alternate between the
maximum, minimum and current readings. The respective MAX or
MIN indicator will be displayed.
To clear the memory, press MEMORY and hold for three seconds.
The maximum and minimum recorded readings will be erased.
Subsequently, if you press MEMORY after the memory has been
erased, the maximum and minimum readings will have the same
values as the current ones.
7
7
NOTE ON °C AND °F
MAXIMUM AND MINIMUM
TEMPERATURES & HUMIDITIES
04/30/2002, 5:59 PM