Preparing Your Camera For Use; Installing The Battery; Charging The Battery - BenQ DC E610 User Manual

2

Preparing Your Camera for Use

2.1

Installing the Battery

We highly recommend that you use only the specified
rechargeable lithium-ion battery for your camera. Make
sure that the power of the camera is off before inserting
or removing the battery.
To insert the battery:
1. Open the battery/SD memory card cover (A).
2. Insert the battery in the correct direction shown
(B).
3. Push the battery all the way down, until the battery
lock lever clicks into place (C).
4. Close the battery/SD memory card cover (D).
To remove the battery:
1. Open the battery/SD memory card cover.
2. Release the battery lock lever.
3. When the battery has come out a little, gently pull it
out the rest of the way.
2.2

Charging the Battery

The battery charge status affects the performance of the
camera. To maximize the performance and life of the battery,
it is recommended that you fully charge the battery using the
specified charger set (charger and AC power adapter), and
then fully discharge it through the normal use at least one
time. Make sure that the power of the camera is off before
inserting the battery.
1. Insert the battery into the charger as shown in the
illustration.
2. Connect one end of the AC power adapter to the charger.
3. Connect the other end of the AC power adapter to a wall outlet.
4. When the battery is being charged, the charger LED indicator lights up in red. When the
battery is fully charged, it turns into green.
The length of the charging time depends on the ambient temperature and the status of
the battery.
A
B
C
D
Preparing Your Camera for Use 5