Preparing Your Camera For Use; Inserting The Batteries; Inserting A Memory Card - BenQ DC 1000 User Manual

Preparing Your Camera for Use

2.1

Inserting the Batteries

The camera is powered by two AA batteries or rechargeable batteries (min. 1600 mAh/1.2V).
Proper operation cannot be guaranteed if you use any other type of battery other than that
noted above.
1. Slide the battery cover open.
2. Insert two AA-size alkaline batteries with the positive(+) and negative(-) poles matching
the directions indicated inside the battery room.
3. Slide the battery cover closed.
•
Always make sure that the camera is turned off before removing the battery.
•
Do not use manganese batteries. Manganese batteries cannot supply sufficient power to
support camera operation.
•
Replace all batteries at the same time. Never mix old and new batteries.
•
Remove batteries from the camera if you do not plan on using it for more than two weeks.
•
The camera body may feel warm after extended use. This is normal.
2.2

Inserting a Memory Card

You can use SD Card with this digital camera. The memory card slot is located beneath the
battery cover, adjacent to the battery compartment.
1. Be sure that the camera is turned off.
2. Slide the battery cover and open it.
3. Insert the card with the label facing up and the arrow pointing in.
4. Close the battery cover.
To remove the memory card, gently press on the edge of the card and release it. Pull the card
out and close the battery cover.
Preparing Your Camera for Use 3