Normal Tap Without Thread & Screw Type Inlet Hose - LG WD-14440 Owner's Manual

I nstallation
Normal Tap without thread & screw type inlet hose
1.
Unscrew the fixing screw to
attach the tap.
Normal Tap without thread & one touch type inlet hose
1.
Untighten the upper connector
screw.
• In case the diameter of the tap is
large remove the guide plate.
• Unable water Tap for connectoring
hose.
8
2.
Push the connector up till the
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
2.
Push the upper connector up till
the rubber packing is in tight
contact with the tap. Then
tighten the 4 screws.
• Turn the middle connector not
to have water leaked.
• Make sure that the rubber seal
is inside the hose connector.
3.
Push the water supply hose
vertically upwards so that the
rubber packing within in the
hose can adhere completely to
the tap and then tighten it by
screwing it to the right.
3.
Connect the water supply hose
to the middle connector,
pushing the plate down.
• To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
• Make sure that there are no
kinks in the hose and that it is
not crushed.