Normal Tap Without Thread & Screw Type Inlet Hose - LG F1022TD Owner's Manual

I nstallation
■
Normal Tap without thread & screw type inlet hose
1.
Unscrew the fixing screw to
attach the tap.
■ Normal Tap without thread & one touch type inlet hose
1.
Untighten the upper connector
screw.
Upper
Connector
Fixing screw
• In case the diameter of the tap is
large remove the guide plate.
Guide plate
Used the horizontal tap
Horizontal tap
Extension tap
Square tap
8
2.
Push the connector up till the
rubber packing is in tight
contact with the tap. Then
tighten the 4 screws.
2.
Push the upper connector up
till the rubber packing is in
tight contact with the tap. Then
Rubber
tighten the 4 screws.
packing
Rubber packing
Middle
connector
Upper
Connector
Middle
connector
• Turn the middle connector not
to have water leaked.
Connector
• Make sure that the rubber seal
is inside the hose connector.
Hose connector
3.
Push the water supply hose
vertically upwards so that the
rubber packing within in the
hose can adhere completely to
the tap and then tighten it by
screwing it to the right.
3.
Connect the water supply
hose to the middle connector,
pushing the plate down.
Upper
Connector
Water supply
hose
• To separate the water supply
hose from the middle
connector shut off the tap.
Then pull the inlet hose down,
pushing the plate down.
Rubber seal
• Your machine comes with
only cold water connection.
• Make sure that there are no
kinks in the hose and that it
is not crushed.
Plate