Reversing The Swing Of The Door; Door Badge - Belling BI60SOXL Users Manual & Installation Handbook

ReveRsInG tHe sWInG of tHe
DooR
(Note: the door is factory fitted with LH
hinging)
1. remove the inner door glass by lifting
upwards.
2. Undo the inner glass stop securing
screws (2-off) & remove the inner glass
stops. Note: a TORX head screwdriver
(size T10) will be required for this opera-
tion.
3. Undo the screws securing the upper
hinge & remove.
4. remove the door assembly from the
lower hinge & rotate such that the door
handle is on the left hand side. Invert
the upper hinge such that it becomes
the lower hinge on the right hand side &
fasten to the front frame ensuring that
the bearing washer from the lower hinge
on the left hand side is fitted to it.
5. remove the lower hinge from the left
hand side & insert into the top of the ro-
tated door assembly. Offer up to the front
frame & secure with both screws.
6. replace both inner glass stops into
their new positions at the bottom of
the door & secure with the TOrX head
screws.
7. Refit the inner door glass.
8. To enable the door to be used in either
left hand or right hand opening mode,
the appliance has been fitted with roller
catches on both sides of the front frame.
installation

DooR BaDGe

If the appliance being installed has been
supplied with a self-adhesive door badge,
this should be fitted to the door using the
cardboard template supplied. The badge
should only be fitted after deciding which
side the door is to be hinged & re-fitting,
if necessary, has been carried out. The
template should be positioned on the bot-
tom & side edges of the door glass.